—  10 & 12 Meter Bands	—  Large Frequency Display with Dimmer
—  Improved Receiver Design	—  New Green Backlite Display
—  Variable Output Power Control	—  Active Frequency Scanner
—  Receiver Clarifier (±0.5kHz)	—  Ten Programmable Frequencies
—  Noise Blanker/ANL Circuitry	—  Frequency Selector Lockout
—  Programmable Repeater Offset	—  Public Address Feature

 

Ranger Communications once again sets the performance and reliability standard for entry level amateur mobile transceivers with
 the latest generation of our popular RCI-2950DX series of cost effective, multi mode, high performance transceivers.

The new models have retained the operating features of its popular predecessors, including programmable repeater offset and
capabilities for a CTCSS tone option — great for increasing repeater activity on 10 meters — and receiver scanning for quick
search of active frequencies. The units offer three methods of frequency selection, non-volatile memory to store and scan up to
ten favorite frequencies, and front panel frequency selector lockout.

In addition, the Series offers an impressive array of design and performance improvements:

—  An improved receiver: designed for increased sensitivity and image rejections.

—  A double FET balanced mixer: for improved receiver intermodulation rejection.

—  New power supply protection: and temperature compensation for improved stability and reliability over wide temperature ranges.

—  Surface mount components: for increased resistance to shock and vibration.

—  Improved display lighting: for easy reading in a wide range of light conditions.

—  Variable Power Output from 2 watts to 25 watts (RCI-2950DX)

To see a side-by-side features comparison chart of the Series versus the other Ranger amateur models, please see the Comparison Chart.



RCI-2950DX & RCI-2970N2 Specifications

General	RCI-2950DX
Frequency Range	10 Mtr: 28.000 - 29.6999 MHz 12 Mtr: 24.8900 - 24.9900 MHz
Tuning Steps	1 MHz, 100 KHz, 10 KHz, 1 KHz, 100 Hz
Emission	USB, LSB, CW, AM, FM
Frequency Tolerance	0.005%
Frequency Control	Microprocessor / Phase-Locked-Loop Synthesizer
Frequency Stability	0.001%
Operating Temperature Range	-10 ºC to + 50 ºC
Meter Function	RF Output, RX Signal Strength, Modulation, SWR (LCD Display Indicates Relative Values)
Antenna Impedance	50 W
Input Voltage	13.8 Vdc
Microphone	400 W Dynamic PTT - 6 Pin
Size (W x D x H)	2950DX - 7" x 10" x 2-3/8"
Weight	2950DX - 4 lb 3 oz
Shipping Weight	2950DX - 7 lb.
Transmitter
RF Power Output	RCI-2950DX - 10 Watts RMS: CW / AM / FM 25 Watts: SSB (PEP)
Current Draw @ Full Power	RCI-2950DX - 4.8 Amps
Modes	USB, LSB, CW, AM, FM, PA
CW Keying	Semi break-in
Carrier Suppression	- 50 dB
Spurious Emission	- 50 dB
Antenna Connector	UHF Type, 50 W
Receiver
Sensitivity	AM / CW: 0.5 µV for 10 db SINAD FM: 0.25 µV for 12 db SINAD SSB: 0.15 µV for 10 db SINAD
Selectivity	- 55db
Image Rejection Ratio	- 65 db
Audio Output Power	2.5 Watts @ 10% THD into 8 W

This "10 Meter" Radio is shipped with a manufacturers warranty and must be returned to the manufacturer if defective.  Because of after shipment modifications to this type of radio, we can not accept returns directly.  We have no control over product modifications after the customer receives the product. 

Check out this site for mod info on CB's and 10 Meter Radios, go to www.cbtricks.com and click on Radio Information.

Notice: All 10 Meter Radios are intended for use by amateur radio operators only.  A license from the FCC is required.

When you purchase a 10 Meter Radio, it is assumed you will abide by the proper regulations.  Truckers-Store.com assumes no responsibility for any misuse by the buyer.  Other restrictions may apply.   

Add these to your Radio Purchase: 
Antenna
Antenna Mounts
Microphone
Coax
External Speaker
CB Accessories