—  AM -FM and PA Modes	—  High Sensitivity Receiver Design
	—  Echo &Talk/Back	—  Variable RF Power Output
	—  Built-in Frequency Counter	—  Blue LED Display
	—  Multifunction Panel Meter	—  Display Dimmer
	— Fully Chromed Housing and Face	—  Heavy Duty Chrome Heat Sink

 

The Ranger RCI-63FFC2 amateur mobile transceiver offers exceptional value for Novice and Technician Class amateurs upgrading to Tech Plus and higher. This entry-level unit is designed for easy, reliable and safe mobile operation. The RCI-63FFC2 transceiver provides excellent receiver sensitivity. The amplifier section has eight IRF520 MOSFET transistors with dual fans for maximum efficiency. The easy-to-use frequency selection system covers the 10- meter amateur band in 6-band segments. Actual operating frequency is accurately displayed in the 6-digit LED display that’s easy to read even in bright sunlight. A channel indicator speeds return to a popular or previously used frequency without interfering with the operator's attention to the road. Selectable Automatic Noise Limiter (ANL) and Noise Blanker assures noise reduction during mobile operation. Front panel RF power output control and RF Gain controls enable the operator to set transmitter power and receiver sensitivity to match operating conditions. Additional front panel controls assure optimum performance under widely varying conditions: —     A +10 kHz switch complements the frequency selection system by shifting the Tx and Rx frequencies up by a known amount for increased driving safety. —     Easy-to-read panel meter - three-functions indicating received signal strength, transmitter power output, and antenna SWR.

 

Shown at the left is the new "Heavy Duty Chrome Heat Sink" attached to the bottom of the RCI-63FFC2.

 

                                                        

General	RCI-63FFC-2
Frequency Range	28.245 - 29.655 MHz
Modes	AM-FM-PA
Frequency Control	PLL Synthesizer
Frequency Stability	0.001%
Operating Temp. Range	- 20 ºC to + 50 ºC
Input Voltage	13.8 Vdc
Antenna Impedance	50 W
Size (W x D x H)	7-7/8" x 10-3/4" x 2-7/8"
Weight	8 Lbs.
Transmitter
RF Power Output	AM-FM: 100W RMS AM: 200W PEAK
Spurious Distortion	- 50 dB
Audio Distortion	10 %
Frequency Response	300 to 2500 Hz
Microphone	Dynamic
Receiver
AM Sensitivity for 10 dB SINAD	0.5 µV
Squelch Sensitivity	0.5 µV
Image Rejection	- 55 dB
Hum and Noise	- 40 dB
Audio Output Power	2.5W @ 10% THD

 

This "10 Meter" Radio is shipped with a manufacturers warranty and must be returned to the manufacturer if defective.  Because of after shipment modifications to this type of radio, we can not accept returns directly.  We have no control over product modifications after the customer receives the product. 

Check out this site for mod info on CB's and 10 Meter Radios, go to www.cbtricks.com and click on Radio Information.

Notice: All 10 Meter Radios are intended for use by amateur radio operators only.  A license from the FCC is required.

When you purchase a 10 Meter Radio, it is assumed you will abide by the proper regulations.  Truckers-Store.com assumes no responsibility for any misuse by the buyer.  Other restrictions may apply.   

Add these to your Radio Purchase: 
Antenna
Antenna Mounts
Microphone
Coax
External Speaker
CB Accessories